When
buried or underground storage tanks are used for the storage and reception of
water for domestic purposes, the following requirements shall be complied with:
The
top of the tank shall ‘be so leveled as to prevent accumulation of water thereon
The
.tank. shall ‘have a complete cement concrete cover leaving a manhole opening
provided with a properly fitting mosquito-proof hinged cast iron cover fitted
with a leak proof cast iron frame. Where tank is of a large size, adequate
number of manholes shall be provided.
No
gap shall be allowed to remain round the suction pipe and arrangement shall be
provided for proper discharge, of spill water from the electric pump by
connecting the pump cabin to the water drain, or by providing a small hole
which will enable the water to flow out.
The
overflow pipes or vent shafts, if provided, shall have a wire gauge cover of
1.5 mm mesh properly screwed tightly to the opening.
Jointing
of Pipes to Storage Tanks
For
jointing steel pipe to a storage tank, the end of the pipe shall be threaded,
passed through a hole in the tank and secured by back nuts both inside and
outside. The pipe end shall be flush with the face of the inside back nut to
obviate corrosion of the pipe threads. For joining copper pipe to steel or
copper tank a connector of non-ferrous metal shall be used having a shoulder to
bear on the outside of the tank and secured by a backnut inside.
Storage
Capacities
The
quantity of water to be stored shall be calculated taking into account the
following factors:
Hours
of supply at sufficiently high pressure to fill up the overhead storage tanks.
Frequency
of replenishment of overhead tanks, during the 24 hours;
Rate
and regularity of supply
The
particulars of water supply requirements of residential buildings and of
buildings other than residences are given under 3.1 and 3.2 of IS: 1172-1983*.
It has been stipulated that, where there is full flushing system a minimum of
200 liters per head per day shall be assured out of which about 45 liters per
head per day may be taken as flushing requirements and the remaining 155 liters
for other domestic purposes.
Pumping
of Water
In
case of multi-storey buildings where the height of the fitting or storage tank
is such as will not permit of their being fed with the available pressures in
the water main, pumping is necessary.
The
house service pumps are usually of the centrifugal type driven by electric
motors, where electric power is available.
In
cases where pumping is necessary, storage tank shall be provided either at the
ground level or partially buried underground, in which case it shall conform to
the requirements given under 11.9 for underground storage tanks.
The
storage tank should have a minimum capacity of 50 percent of the overhead
storage tank.
The
advantage of the storage tank is that it can be fed continuously during low
pressure hours and, therefore, the pump can be worked at any time of the day
and the overhead storage ‘may be replenished continuously.
The
pump also works at a steady head and there is no chance of overloading.